校正峰电位漂移偏最小二乘极谱催化波同时测定轻稀土

应用Ｍ２７３．Ａ电化学系统中的线性扫描技术，确定了８．０×１０－５ｍｏｌ／Ｌ二甲酚橙及ｐＨ４．０ＨＡｃ－ＮａＡｃ缓冲体系为偏最小二乘极谱法同时测定Ｌａ、Ｃｅ、Ｐｒ、Ｎｄ、Ｓｍ、Ｅｕ的最佳极谱体系。６种稀土元素的线性范围均在１．０× １０－７～１．２ × １０－５ｍｏｌ／Ｌ。并对极谱峰电位随浓度漂移进行了校正，提高了方法的准确度。     

碱金属和重金属叠氮化物的感度和导电性研究

分别用EHCO和DV－X_α方法，计算研究了α－NaN_3、β-NaN_3和AgN_3的能带结构和原子簇电子结构. AgN_3与NaN_3相比：带隙(△Eg)较小、带宽(BW)较大，因而电导率较大. 比较前沿晶体轨道(CO)和前沿分子轨道(MO)的能级、组成及电子在其间的跃迁；预示AgN_3比NaN_3更敏感、更易分解和起爆．还从电子微观层次揭示了金属叠氮化物的导电性和爆炸性之间的联系．     

离子缔合富集明极溶出伏安法测定痕量碘——Ⅰ.以丁基罗丹明B为离子缔合剂

本文提出在0.1mol/LH_2SO_4,7.5×10~(-4)mol/LBr~-和6×10~(-5)mol/L丁基罗丹明B(R~+)的底液中,在+1.0V下,I~-离子于玻璃电极上被氧化生成I_2BrR离子缔合物,藉以阴极溶出伏安法测定碘、I~-离子浓度在1～50ppb范围内与峰电流呈线性关系。用于食盐中痕碘的测定。     

Dynamic surface tension of micellar solutions studied by the maximum bubble pressure method. 1. Experiment

The effect of the micelles on the dynamic surface tension of micellar surfactant solutions is studied experimentally by means of the maximum bubble pressure method. Different frequencies of bubbling ranging approximately between 1 and 30 s^–1 are applied. The time dependence of the surface tension is calculated using a dead time correction. Water solutions of two types of surfactants with different concentrations are investigated: sodium dodecyl sulfate and nonylphenol polyglycol ether. The surface tension relaxes more quickly in the presence of micelles. The characteristic times of relaxation of the surface tension seem to be in the millisecond range. The time constants observed experimentally are explained in terms of the theory of surfactant diffusion affected by micellization kinetics.     

偶极积分与Boys法分子轨道定域化

定域分子轨道在分子体系的化学图象和物理图象之间充当重要的桥梁作用,它的产生依赖于定域化准则,其中最普遍使用的是Foster-Boys和Edmiston-Ruedenberg(E—R)提出的两种定域化准则。这两种定域化准则是等价的,因而结果也是一致的。但对于E—R定域化来说,由于涉及到大量的多中心积分的计算,计算极为费时,因而远不如Foster-Boys定     

DFT study of the conductance of molecular wire:The effect of coupling geometry and intermolecular interaction on the transport properties

The density functional theory (DFT) combining with the non-equilibrium Green functions (NEGF) method is applied to the study of the electronic transport properties for a Di-thiol-benzene (DTB) molecule coupled to two Au(111) surfaces. The dependence of the transport properties on the bias, the coupling geometry of the molecule-electrode interface, and the intermolecular interaction are examined in detail. The results show that the existence of the hydrogen atom at the end of the DTB molecule would significantly decrease the transmission coefficients, and then the differential conductance (dI/dV). By changing the position of the DTB molecule located between two electrodes a maximum value of calculated current is observed. It is also found that the intermolecular interaction will strongly influence the transport properties of the system studied.     

Uncertainty of the Thermal Conductivity Measurement Using the Transient Hot Wire Method

This work deals with uncertainty analysis of the thermal conductivity measurement using the transient hot wire method. The characterization is made from a sample of low-density, polyethylene BRALEN SA 200-22. The utilized experimental data are obtained from the test measurements performed on the air at room temperature. The sources of measurement errors are analyzed and the uncertainty of the measured value of the thermal conductivity is evaluated. The analysis shows that in the present case the uncertainty of the thermal conductivity measurement is about ±3.3% for 68% confidence level.This revised version was published online in November 2005 with corrections to the Cover Date.     

Isolated square planar metal complexes of carbon

Based on the group theory analysis and quantum chemical calculations within the framework of SW X _α method (in relativistic approximation for core electrons and non-relativistic for valence ones), the existence possibility of square planar complexes [M₄C] and [M₄C]^2? (M = Al, Ga, In, Tl, Sc, and Y) in gas phase has been shown. The extraction of Kt₂[M₄C] square planar complexes of carbon in the crystal state is possible too. A high stability of these complexes, in comparison with usual tetrahedral, is achieved due to the formation of five-and four-center bonds (bonds M-M and M-C).     

Computational study of conformational preferences of thioamide-containing azaglycine peptides

The effect of thioamide substitution on the conformational stability of an azaglycine-containing peptide, For-AzaGly-NH2 (1), was investigated for the sake of finding possible applications by using ab initio and DFT methods. As model compounds, For-[psiCSNH]-AzaGly-NH2 (2), For-AzaGly-[psiCSNH]-NH2 (3), and For-[psiCSNH]-AzaGly-[psiCSNH]-NH2 (4) were used. Two-dimensional phi-psi potential energy surfaces (PESs) for 2-4 were calculated at the B3LYP/6-31G*//HF/6-31G* level in gas (epsilon = 1.0) and in water (epsilon = 78.4) by applying the isodensity polarizable continuum model (IPCM) method. On the basis of these PESs, the minimum energy conformations for 2-4 were characterized at the B3LYP level with 6-31G*, 6-311G**, and 6-31+G** basis sets. The remarkable structural effect of thioamide substitution for 2-4 is that beta-strand structure is observed as a global or local minimum. The minima of 2-4 are also compared with those for glycine and thioamide-containing glycine peptides. Our theoretical results demonstrate that compounds 2-4 would be used to design controllable secondary structures.     

Molecular Replacement Studies of Cucurmosin from Cucurbita Moschata:Structure Homology with Trichosanthin

1 INTRODUCTION Many plants contain proteins that are capable of inactivating ribosomes and therefore are called ribosome-inactivating proteins or RIPs[1]. RIPs are RNA N-glycosidases that inactivate ribosomes through a site-specific deadenylation of the large ribosomal RNA[2, 3]. RIPs are also capable of inactivating many nonribosomal nucleic acid substrates and can be considered as polynucleotide: adenosine glycosidases[4～6]. There are two types of RIPs: type I, single chain pr…